...attached to the belt turns. if one of the pulleys is seized and wont' turn properly, can overheat belt. 5. check pulley surface for cracks. must be smooth. 6. finally are your belts the correct
Question about 1997 Protege
...Pulley that the belt will go on. b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right. c. Using a Serpentine Belt Tensioner Tool or Wrench ...
...Pulley that the belt will go on. b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right. c. Using a Serpentine Belt Tensioner Tool or Wrench ...
belt over the final pulley. As you begin to allow the tensioner back into contact with the belt, run your hand around the pulleys and make sure the belt is properly seated in the ribs. If not, release
belt over the final pulley. As you begin to allow the tensioner back into contact with the belt, run your hand around the pulleys and make sure the belt is properly seated in the ribs. If not, release
BELT UNDER THE PULLEY. IF IT SLIPS FROM YOUR BREAKER OR YOU CAN'T HOLD IT YOU COULD BE SEVERELY INJURED. TRY MOVING AND SLOWLY RELEASING THE PULLEY BEFORE YOU ATTEMPT TO PUT THE THE BELT UNDER THE
...pulley and belt guide.Loosen the belt tensioner pulley assembly, then position a Camshaft Belt Adjuster tool T74P-6254-A, or equivalent, on the tension spring roll pin and retract the belt tensioner ...
...belt for pulley.2 belt running on the botton of the pulley and worn pulleys. To check measure across the top part of the pulley and the widest part (back) of the belt should be the same if not ...
Question about 2012 3 i Touring 4dr Hatchback 2.0L 4-cyl. 6-speed Manual w/SKYACTIV-G
...belt on this pulley on the back side.), then put the belt over the A/C pump bottom front. Keep tension on the belt so it stays in place. Now put that socket back on, push up to lift the tensioner ...
Question about 2000 B-Series
...belt on the back pulley, then put the front belt back on the front pulley on the aircon compressor. you need a cerpentine belt tool. check out all the pulleys and you will find that one has a square ...
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions