...pulley to change the timing belt if not how do i do it You dont have to remove the pulley to take out the timing belt. You can use a 1/4th inch ratchet to pull the pulley. Then the belt will come ...
...move the belt into and out of the pulleys. have the new belt ready after you pull the old one, put it around all BUT the tensioner pulley and it will be MUCH easier to put on if you are by
Question about 2000 Trooper
...belt to each pulley. 014RW00005 Legend (1) Alignment Mark on Timing Belt (White line). (2) Alignment Mark on Camshaft Drive Gear Pulley. (3) Alignemnt Mark on Cylinder Head Cover LH. 6. Install ...
...pulley, lower timing belt cover, timing belt tensioner, and timing belt. Compress the timing belt tensioner and if the original ring pin isn't available to retain the tensioner a small allen wrench ...
...Pulley that the belt will go on. b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right. c. Using a Serpentine Belt Tensioner Tool or Wrench ...
...crankshaft pulley. Tighten center bolt to the specified torque.Torque 167 N-m (123 lb-ft) Crankshaft pulley; P/S belt Tighten fixing bolt to the specified torque. Install the belt on the idler
...pulley. To refit the belt route as shown over every pulley except the alternator, once again release the tensioner and fit the belt to the alternator. See that the belt is properly seated over every ...
pulley against belt. 5. Ensure belt is taut between injection pump sprocket and tensioner pulley as well as crankshaft sprocket and camshaft sprocket. 6. Position tensioner lever [8] against tensioner
belt pulley and the right bank camshaft timing belt pulley. Insert a 1.4mm piece of wire through the hole in the pusher to hold the rod in. Install the pusher assembly while pushing the tension pulley
Question about 1996 Trooper
belt pulley and the right bank camshaft timing belt pulley. Insert a 1.4mm piece of wire through the hole in the pusher to hold the rod in. Install the pusher assembly while pushing the tension pulley
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions