Questions & Answers for: pull starter wont engage

Question about 2002 XVS 1100 Dragstar Classic

1 Answer

...It has a starter clutch on the fly wheel. You will need to remove the left side case cove to access it. You will need to pull the flywheel with a puller as the starter clutch is behind the ...

Ad

Question about 2002 XVS 1100 Dragstar Classic

1 Answer

...pull starter, there is a clutch, which from the sounds of it, is not working properly. Sometimes you can give the handle short gentle pulls (aprox. 5 inches) and sometimes it will engage. Otherwise, ...

Ad

Question about 2001 Super Duty F 450

1 Answer

...pull the starter again, you can try to see if the ring moves in and out or appears to be slipping around on the flex-plate. The flex plate could be loose on the crankshaft. In any case, the engine or ...

Question about 1999 Durango

1 Answer

...wont start. also the abs lights are on. Dont know if its the starter or the alarm malfunctioning. may work may not...on older cars when the starter went bad and the car wouldn't start you could tap ...

Question about 1992 Eclipse

1 Answer

wont turn over when i try to start????? If I had to guess, I would say that the starter is not engaging the engine. When you turn the key to start, it energizes the starter and a solenoid that "pulls"

Question about 1998 Taurus

1 Answer

pull keys out of ignition while car was still running and while in drive . driver reset shift lever to park and pulled keys out again . This time made a "Starter Engaged sound " now car wont

Question about 1998 Taurus

1 Answer

pull cord wont spin the motor pull cord wont start up motor The engagement "dog" is probably rusted in place. Try spraying WD 40 on the recoil mechanism as you pull the starter cord

Question about 1998 Taurus

1 Answer

...pull the starter and fix the solenoid or replace the solenoid. It is engaging the armature with out engaging the pinion into the ring gear or the pinion override clutch is failed. Have a reputable ...

Question about 1995-1997 Chevy 1500 Truck Ignition Starter Alarm Switch

1 Answer

...the solenoid is not engaging. I would pull the starter and change the solenoid on the top of the starter. Be sure to disconnect the battery cable before working to remove the starter. Hope this

Question about 2003 FJR 1300 A

1 Answer

pull starter out got checked ok replaced relay still no good, new starter switch that was the problem the starter motor is spinning but not engaging so put new clutch gear in still wont engage looking

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66957 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...