Questions & Answers for: pull engine code 1998 ford

...pull of the rubber air intake hose off the engine, hold the eng. at hi idle and spray an approved throttle body spray cleaner in, use at least half the can, then lower the idle and spray until the ...

...ENGINE LIGHT IS ON. HAD IT READ AT AUTO ZONE, SAID IT WAS AN EGR VALVE. I REPLACE THIS ABOUT 14 MONTHS AGO. The EGR is one piece in a larger system. Most autozone type places only read the code and ...

...Engine light until it suddenly got worse and it would not correct itself after ******** to N and back to D. The code then showed up as P500 or P502. The VSS is about $50 at NAPA or about $25 at ...

...engine light is a way for the computer to let you know that there is a problem with the engines sensor, ignition system or fuel system. You will have to have a mechanic or go to auto zone and have ...

...engine light that is on, it indicates the computer is sensing a fault. This might seem odd, but turn key forward to on/run, but do not start the car. Press the gas pedal to the floor and release 3 ...

...to 30 miles. Then speedometer drops to zero miles, engine still runs at RPM but transmission quits pulling.. After a short time speedometer returns, trans pulls again. This continoues. hav car ...

Engine does not start: LED flashes rapidly Leave ignition on until the LED starts to flash a 2 digit code: (sequence- pause-sequence) Check the following codes: Code flashes: 1:3 Key code not received

pull the EGR valve open while monitoring engine RPM's & DPFE voltage. There should be a noticable difference in RPM's with the EGR open * Clean out the EGR valve and/or tubing to remove deposits *

pulled engine code 705, changed tr sensor and checked wiring. still the same. clear the codes and run it see if code comes back

...ford taurs? please I'm thinking that because my car has no power when i'm driving on the highways The fuel filter is located under the car on the passenger side right in front of the passenger rear ...