Questions & Answers for: pull cord latch

...the hood to see if it will pop up enuf jus to get ahold of the latch(under the grill on the drivers side). You can also get to the latch from under the car but make sure you pull the cord inside ...

...pull cord. when u turn the key there is a little piece on that cord that the key pulls on... u can only fix it with the trunk open though. so to open it get the remote or have a second person to open ...

...Pull Cord I have a 2001 Honda Prelude and the pull cord for the hood seem to have come loose while the hood was closed. How can i open the hood when it is closed completely so i can reattach the pull ...

...cord firmly and pull it from right to left (away from the latch). This is the emergency cord to open the door after a latch failure. remove any debris that would hamper the operation of the latch ...

...pull cord close to the area of the outside fill door. have someone push in on door while you pull lever look inside trunk at area of filler tube for a latch or 'rip cord' to open it. I could not find ...

...pull cord inside car is broke to open the hood of car. How can I open the hood? my Malibu has a very hard to pull latch also. only way is to crawl under front of car and follow the cable to where it ...

I Brock the latch pull how do I open the hood by hand the cable cord is still attached---use pliers to grap the cable from just behind the latch and pull, but when you do get it to open---replace asap

...cord out, it should 'keep' it that spot if you pull a certain direction, cant recall if it is up, or down, left or right, and pulling it opposite direction releases the cord again The latch system is ...

...pull cord will not release. BMW Z4 convertible top opened and now wont close. Motor runs then stops. Latch is stuck and the emergency pull cord will not release. How do I get to the latch to free the ...

...cord has been extended past its limits (fully extended) and can't be pulled any further to pull the latching mechanism far enough to release and allor the winder to do its think. (I used to manually ...