Questions & Answers for: Mercury Mountaineer how to pull codes

pull codes for free. My 2002 M Mountaineer had the same problem and was fixed by reading the code that showed a leak in the gas tank pressure via the cap. When I replaced this with a good after market

Ad

what solenoid specifically? What was the trouble code? Most parts stores will pull OBD-2 codes for you for free and give you a brief description of what they mean. I would try that then come back here

Ad

Question about 2004 Mountaineer

1 Answer

needed and it took me all of 5 minutes. Just pop off the front of the panel closest to the door and pull it back. Use a light and you can see the large 5 digit code on top of the module

Question about 2002 Mountaineer

1 Answer

...You will see two panels where the wall seat belt is located, remove the top panel first and then pull the lower panel out.Then pull the lower trim panel forward CAREFULLY. Towards the front (near ...

Question about 2003 Mountaineer

1 Answer

...on and when im drive it flick off and on what does that mean You won't know until you have the code pulled that set the check light. You have a system malfunction The codes will be used to diagnose ...

Question about 2003 Mountaineer

1 Answer

...way to get to the computer module is look behind the right rear panel in the "truck" space. First pull off the right rear seat belt panel then pull back the lower panel. You will see a green plug ...

...sensor or has a problem with the ABS control module and/or pump. Need to have the ABS codes pulled by a service center. Also, some auto parts stores can pull codes and may be able to pull ABS

My check engine light is on. My vehicle won't go in reverse and can only go about 30 mph in drive mark, you should see about pulling the engine light code. you may get a code like 1756 or 0700 but you

...2003 mercury mountaineer 10 times There is a fault in the airbag system if you have a good scan tool that will read air bag codes if not you might have to take it to a shop and have em pull the ...

...in my 2007 Mercury mountaineer Open the right/rear door. Fold the right/rear seat down. Carefully pull the trim panel where the right/rear seat belt pivot/height adjuster is housed. Once removed, ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...