o/d light flashs The PCM (powertrain control module) is indicating a malfuntion in the transmission,so the code should be pulled out and diagnosed.It is likely a shift solenoid code,or gear ratio ...
...issues o2 sensors,ecu ,vacume leaks ext...some shops offer free code pulling and that will help you know where to start if you have an autozone around i know for sure they will pull the codes for ...
...Pull the abs fuse until ready to have vehicle serviced. If already serviced, pull neg batt cable for 3 minites to clear codes. But make sure you know the radio key code if you want that to work
Check Engine light is on. have code pulled from light when code is pulled and problem fixed light will go off could be hundreds of different things the code will tell whats wrong by haveing it pulled ...
Question about 2002 F250 Super Duty SuperCab
...pull but stop at like 60 mph like you hit a switch. This is a change from wheni pulled my camper to Georgia in october it pulled good but the check engine light came on there were no codes when i ...
abs light came on bring it to a service repair station an have the abs codes pulled the most likely cause of this is a faulty rear wheel speed sensor you will have to have the code pulled from the abs
...the codes you could spend alot of money chasing the problem.If you have a AutoZone near you they will pull the codes for free. That is were I would start and than we can go further with the
...pull the computer codes on my 91' Mustang gt How do I pull the computer codes on my 91' Mustang gt If you have a check engine light on the dash, you would use a jumper wire attached to a ...
p1299 and p0357 2003 ford crown victoria 4.6L vin w ...........i replaced the cht and the coolant temp sensor and i was getting a p1299 code and then i pulled the thermostat out and it got rid of the ...
Question about 2006 Five Hundred
...dealer. Secondly you can do it this way: Location for key pad entery code; 2006 Ford 500. Need to pull panel off below steering wheel (I used a 9/32 socket) Then look for 3 10mm nuts, 2 @ top 1 on ...
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions