Questions & Answers for: pull balancer 2001

balancer on a 2001 Dodge ram 2500 v-10 and install the new one. Do I have to pull the radiator? yes. at the very least the fan shroud and fan. Here is a link to a 2001 Dodge Ram Factory Service Manual

do u need a 2 arm or 3 arm puller to take off balance pulley on dodge stratus i would use 3. more stability, straighter pull

...2001 rover 25 Mark drive-shaft and yoke to re-install in same location to maintain factory balance Loosen and remove small "U" clamps at yoke end of drive-shaft Pry drive-shaft out of yoke, pull off ...

what puller should i use to pull the crankshaft pulley? 2.4 l Go to your local auto parts place. They may have the tool and will loan it to you. It might take a harmonic balancer puller.

...balancer bolt to pull in back in place make sure pulley keyway line up right a little bit engine oil inside balancer and a little oil on harmonic balancer bolt as you tighten harmonic balancer ...

...it has one. Use 1/2 impact wrench for this operation. Fit harmonic balancer puller and pull off. If no bolt ,fit puller and pull off. It will be keyed so installing new unit will be reverse to ...

...Pull the passenger side tire. remove the inner fender well cover. Remove the bolts to the sub frame and lower it. Install a harmonic balancer pulley remover and remove the balancer. remove the crank ...

How do I pull a harmonic balancer on a 2001 oldsmobile aurora 3.5L? They make a special harmonic balancer puller, an auto parts store will have it.

for 3 holes to pull balancer off crank You could either have a balancer with 6x100 or 8mm125 thread. But, past experience has taught my that you may need to drill out the holes and tap to next size up

...if there is one fit a harmonic balancer remover puller pull the balancer of Note take care in the removal as there may be a crank sensor at the balancer best get a workshop manual for photos on the ...