Questions & Answers for: pto clutch

...pto clutch could need to be adjusted.Does the machine **** down when you try to engage the pto?If so also check the seat switch.To adjust the pto clutch you need a 9/16' wrench and tur all three lock ...

...PTO clutch, or in the wiring that goes to it. Inspect the wiring for any obvious spots where insulation has rubbed off or burned. Also look at the wiring at the back of the PTO engagement switch for ...

...pto clutch stays engeged and i cant shut it off(pto) i have a series 2500 model gt 2544 tractor The clutch has it's own brearings in it.  You have to replace the hole PTO.Sometimes you can ...

...PTO clutch on the bottom of the engine shaft. There's a 5/8" bolt that goes up through the clutch into the shaft. Remove it, but then turn it back in about 10 turns and use a wheel puller to start ...

...mowers have a safety switch between the PTO switch and clutch. A safety switch or relay is most likely the problem. Hope this will help ya. I have a GT245. When parking brake is released, motor

...PTO clutch. It doesn't it reaching the clutch. You need to unplug the PTO clutch and check to see if voltage is there. If it is there then clutch itself is bad or the wiring from the connector to ...

...on your comment, you are right, the Clutch/Brake will not turn off the PTO as long as you remain in place (and don't try backing up). If you want the PTO to disengage you must turn off the PTO

...pto clutch will not engage, I have 13 volt at the plug for the clutch , so ordered and installed new clutch... Still will not engage checked volts again had 9.3 Not sure if it could be the pto switch ...

...if you need more tips and info." How To Repair Ripped Out Wires On An Electrical PTO Blade Clutch lawn tractor pto wire Google Search Troubleshoot Replace mower PTO CLUTCH Broken PTO clutch wire ...

PTO clutch lead wires and PTO switch. Look for signs of overheating (melted connector housing) or loose connections. If no problem found, run 'til failure. Then with engine off and key in RUN position