Question about (B000194UBA) Compact Refrigerator
PTC starter. Checked the compressor coil resistance and it ws fine. Replaced the PTC starter with Item #: 1268268 from Repairclinc.com and it started right up. The PTC starter was an exact replacement
Question about Side by Side 26.0 Cubic Foot Total Capacity Refrigerator
...PTC relay onto compressor terminals Transfer remaining wires from OLD PTC to the correct terminal on the new PTC relay. TEST compressor start before installing cover... PLUG in unit After the test ...
Question about Side by Side 26.0 Cubic Foot Total Capacity Refrigerator
...and is what starts the compressor and also protects the compressor its located in the lower rear area,unplug the ptc and replace it with an exact replacement available from any appliance parts ...
Question about 25.6 Cu. Ft. Side-by-Side Refrigerator with Thru-the-Door Ice and Water - White
...this ptc overload relay cuts out the compressor to protect it,it will keep trying to start the compressor till the ptc burns out,it just unplugs off the compressor and a new replacement plugs back ...
Question about 25.6 Cu. Ft. Side-by-Side Refrigerator with Thru-the-Door Ice and Water - White
...PTC motor starter for the compressor gets fried. The part can cost $50 or if you shop online as low as $2. What happens is if power briefly goes off and compressor has been running, the pressure is ...
...on them? no there is reset,but,the ptc overload relay plugged into the compressor is bad,purchase a new replacement ptc overload relay and plug in into the compressor and it will again cool ...
...compressor. Remove the blade connector and pull the PTC relay to the left, sliding it off the pins attached to the compressor. Step 5:Slide the relay on the connector pins, reattach the blade ...
...body,unplug the unit,then on the left side of the compressor in the lower back side is the ptc,unplug it off the compressor and get a replacement,this is what helps start and operate the ...
...compressor. Remove the blade connector and pull the PTC relay to the left, sliding it off the pins attached to the compressor. Step 5: Slide the relay on the connector pins, reattach the blade ...
Question about (VT60GNV) Wine Cooler
compressor. VSD fault 18 is supossedly a main motor PTC overtemp code, but there is only the hall effect sensor in the motor. where is this PTC thermistor? The PTC typically goes into motor at weather
Usually answered in minutes!
3,171 Questions
1,894 Questions
1,239 Questions
1,098 Questions
927 Questions