Questions & Answers for: pt cruiser idle problems

pt cruiser rough idling i have pt cruiser 03 has 50 k miles non turbo ,every time i stop on light it viberates like every 10 seconds ,i tried and clean intake with spray cleaner the car didnot start ...

...PT Cruiser. When starting in the I have a 2006 PT Cruiser. When starting in the AM (cold), it idles around 1000 rpm.. until I touch the gas. After I let off the gas (not revving, just off idle), the ...

Pt Cruiser idles rough at stop lights/ poor gas mileage. I have a 2005 Pt Cruiser that acts like the engine wants to cut off when I stop at red lights. Plus the car only gets about 250 miles to a tank

...pt cruiser which t he a/c is overheating...it is noticeable when standing in traffic as the engine will "stutter" while idling.... My 2002 chrysler PT Cruiser engine Rev's itself about twice when i ...

...PT Cruiser. On a cold start it starts on fast idle which is excessively fast. It is actually unsafe to put the car in drive. It will stay on fast idle for 5 minutes before dropping, but then the ...

...cruiser with rough idle but drives good rough idle but drives good I had same problem...Clean thottle body...Take hose from air cleaner off,two silver clamp...Take cover off throttle cable,open ...

...pt cruiser 2.4? The Idle Air Control (IAC) on a 2001 Chrysler PT Cruiser is controlled by the Powertrain Control Module (PCM).  There are no mechanical adjustments.  If your engine is not ...

pt cruiser to have a rough idle, cylinder 1 misfire, and bogging upon acceleration? I have a stick shift 2002 pt cruiser that has a rough idle after a few seconds of the car running, when I accelerate

...PT Cruiser ? After starting engine and I turn on heater blower motor the engine start idling rough and almost stalls. Blower settings low to high make no difference. Soon as you turn blower off idles ...

...PT Cruiser turbo backfiring etc My 2006 PT cruiser turbo cuts out and backfires when I accelerate quickly. if I feather it, it does ok. Also getting crummy gas mileage? My Haynes manual doesn't ...