Questions & Answers for: Toyota Tercel proper fill clutch fluid

fluid is it a big deal to replace? You must remove from it's mount and empty out any fluids that is in tank.fill the tank with water and locate where the leak is coming from. wash tank a few times and

Ad

...clutch and pressure plate are worn or hopefully just that the master or slave cylinder is leaking.The master cylinder is under the hood opposite side to the steering wheel and slave cylinder at the ...

Ad

...clutch master cylinder. If fluid is full likely that is your problem. If fluid is low, check system for leaks and replace anything that is leaking, then bleed air as you would with a brake system. ...

...fluid for your clutch is low.  If your car has an hydraulic clutch your fluid may be low ck under the hood for a small resesrvior and ck the fluid in it- also there may be an

fill the transmission fluid in a 1984 toyota 4wd tercel with a manual transmission look for the dipstick it will have a small cap on it possibly red in color cap not one as big as oill dip some have a

...fluid coming out of the differential. This has a separate fill hole very similar to the manual transmission's. In this case, I've used a funnel with a piece of hose stretched over the end. In both ...

...then check fluid level and add, then run through gears again until the proper level has been attained. That's the easiest way. Standard transmission are through the fill cap/dipstick combo as

...fill the clutch fluid? Reservoir should be on the firewall near the brake M/C. Look for a little cup like in pic below with a tube coming out the bottom. That tube goes to your clutch M/C as you can ...

Question about 1984 Tercel

1 Answer

...is full, if not, fill it with the proper fluid and see if you can bleed the air out of the system. if it is full then you probably will need to replace the clutch master cylinder or slave

Question about 1994 Tercel

1 Answer

...there will still be air in it. However I think the problem is in the clutch master cylinder ---piston rubbers leaking fluid back to reservoir. Replace the m/cyl with new item and bleed out

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...