Questions & Answers for: Harley Davidson proper fill clutch fluid

...fluid. Nothin. Whats wrong? Glider, had this post on clutch adjustment by the book... http://www.hdtalking.com/transmission_clutch_and_primary/853-clutch_adjustment_by_the_book.html Also go to the ...

checking and filling fluids I do not have a clue where to check the clutch/gear oil or trans. and if low what to use Clutch checked by removing derby cover. Use harely chaincase lub. Tranny is on ...

...proper procedure? remove the drain and fill plugs inspect o-rings for tears after fluid is drained, reinstall drain plug and tighten to 14-20 lbs fill tranny with Harely Trans fluid - 20-24 OZ until ...

...cable, make sure its engaging well. if clutch cable is adjusted well and still does not work, you need to tighten up clutch plates Check the primary fluid, make sure it's not low, or over

...Fill to proper level with the fourth. Your dipstick is marked with a "Full Cold" and "Full Hot" mark. Fill to "Full Cold" mark and check again after warming up the engine. Use Syn3 in the primary or ...

proper clutch adjustment first. If the fluid in the primary chaincase smells "burnt" then you'll most likely need to replace the clutch plates and fluid. I strongly recommend that anyone attempting to

...the clutch. Stand the bike straight up and fill the primary with 20W50 engine oil until the level just comes to the bottom of the clutch drum. Do not overfill or the clutch will drag. Good Luck ...

...is a 7/32. Install the outer primary cover. Fill with fluid til it's just over the bottom of the plates. Adjust the clutch cable so that you have the thickness of a quarter at the perch. There you

...With bike upright, fill to bottom of clutch plates: ...

...clutch fluid level in the reservoir at the FILL LEVEL with motorcycle in an upright position. THEN remove the secondary clutch actuator cover, cover the exhaust pipe(s) with towels and place a ...