...prop seal on a 1987 50hp evinrude you need to disassemble your gear case, remove the prop shaft, and then replace the seals. however, if you are careful, it is possible to hook them out with a ...
Question about 2000 Silverado 1500
seal fits in it can were out and let the prop shaft flap about, this in turn rips the seal to bits,,,also the yoke has a polished part on the end that go's over the spline into the end of the gear box
...might fix it and fix it and fix it again .400 sounds steep to me it might be shift rod seal or drive shaft seal or prop seal.or a combination of all three.check for fishline around prop shaft first
Question about 2000 Silverado 1500
any ideas before I start to pull apart? It sounds like you need to change prop shaft seal. While at it check water pump impeller (in sure it is still playable). Also change seal under pump wear plate
prop can not be put on, it should be replaced. While its out check the area the seal rides and see if it is worn badly. If a deep grove and it's shedding metal, you should replace it. I've had
Question about 2000 Silverado 1500
thanks, Duane I believe you got fishing !one wrapped between prop and seal. Remove prop and inspect for line and leak around seal. If not, than the seal under water pump plate is leaking your gear oil
...shaft is leaking ---split the leg and replace or the seal behind the prop is leaking -- remove the prop and replace I would go for the drive shaft seal as it is under pressure from the water
Question about Yamaha 6B500 Jet Boat Engine Impeller
...seal and if so could the thrust washer have damaged it? two seals on the prop shaft.fishing line is deadly on these seals.take it to a shop that has the tools to do the job. It's quite simple to ...
Question about Yamaha 6B500 Jet Boat Engine Impeller
I have a Johnson 130 HP that has oil coming from the propeller area even when not in use. Thanks Take off prop see if it is coming from props haft,if so replace seal
Question about Yamaha 6B500 Jet Boat Engine Impeller
seal. Can the prop be replaced? Centrifugal pumps do no have props, they are called impellers. Yes can be replaced, but if seal is leaking replace seal. Sometimes, depending on the reason for the seal
Usually answered in minutes!
413 Questions
78 Questions