...PATS/PCM ID do not match. Problem with SCP link. CLEAR the stored DTCs. CYCLE the ignition key from off to run. RETRIEVE continuous DTCs. If DTCs are present, GO to Instrument Cluster Diagnostics ...
...PATS module will flash the THEFT indicator for one minute, then flash diagnostic trouble code 16 ten times to indicate there is a problem with the module communication network circuits or the PCM is ...
PATS Key. There is no issue with the PATS key itself, but the key must be programmed into the PATS memory (unless the maximum number of keys are already programmed). You will have to get it programmed
...key off. PATS Transceiver The PATS transceiver is located under the steering column shroud and communicates with the PATS ignition key. During each vehicle start sequence, the PATS transceiver reads ...
...PATS key, issuing a signal to the PCM to control the starter and fuel injectors enable, and initiates the key interrogation sequence when the ignition key is turned to the ON or START position. ...
Question about 2008 F 450 Super Duty
...PATS key is necessary. This system contains a new feature named unlimited key mode. This feature allows a customer to program more than 8 vehicle keys if requested. Each vehicle in unlimited key mode ...
Question about 2008 F 450 Super Duty
...PATS key. Program the new PATS key. Refer to Key Programming Using Diagnostic Equipment in this section. Clear the PCM DTCs. Key in OFF position. Key in ON position. Retrieve the PCM DTCs. Is DTC ...
Question about 2009 Mountaineer
pats key. There is a transponder in the head of the key - when put into the lock cylinder a antenna behind the plastic steering column energizes the transponder which makes it send it's unique code to
Question about 2006 Navigator
...PCM Go To Pinpoint Test A . B2431 Key Program Failure (Defective Key or Transceiver) PCM VERIFY if using correct PATS key, if defective USE new key. - All other DTCs PCM REFER to Section 419-10
Question about 2006 Navigator
...program. The PATS system should now recognize the new key and it should be able to start the engine. If the new key does not work, please consult with an Ford Dealer or Automotive Locksmith to assist ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions