harmonic balancer suppose to jiggle? When I am driving my Holden Commodore VS 96 model it sounds good until I put my foot down on the pedal and 1/4 way down it starts to make a whistle sound.. Is this
harmonic balancer my harmonic balancer an crank sensor is new an the harmonic balancer still vibrates what could be the problem. Is the pully on correct?
harmonic balancer curt solved the heat issue.ty now the problem is the harmonic balancer.noticed it was wobbling.drove it a short distance and the pulley came off.now my question is can i just replace
...is anything that will give us complications when takin it off..Thank you for any responses Do you have the harmonic balancer removal puller? It should come off with no problems after belt is
harmonic balancer puller. Not the two or three armed pulley puller, but a harmonic balancer pulley puller-the pullers with jaws that hook around the outside of pulley can ruin a harmonic balancer. Use
...harmonic balancer keeps coming out causing the belt to come off I've tapped it back on a couple of times it keeps coming back out only now my car has a loud knock what could this be and how do I fix ...
Question about LIS 52650 Harmonic Balancer Installer
harmonic balancer pulley on a 07 kia optima a day later it was loose and the belt keep coming off harmonic balancer pulley has been repaired twice with the same results the pulley will not stay in the
Question about LIS 52650 Harmonic Balancer Installer
...harmonic balancer is almost an inch out of place what can coo What could make that happen I've never had a problem with a harmonic balancer in 30 years of driving it a 2000 Chevy Impala You figure ...
Question about LIS 52650 Harmonic Balancer Installer
...harmonic balancer cause a belt to misalign and cause premature belt wear? 2016 Dodge Journey 2.4 liter 2wd. Have replaced belt twice in 10000 miles. This time replaced idler pulleys and new belt but ...
Question about LIS 52650 Harmonic Balancer Installer
...harmonic balancer from rubbing the timing cover? There was a key inside the shaft in the harmonic balancer was put on the key was not set right, and it was pushed back into the sprocket on the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions