Front End Noise in 2005 Nissan, Maxima When I am driving my 2005 Nissan Maxima when I start to slow down and start to release the brake around 40 miles per hour I hear a very loud tapping noise in the
...for a second, only when the starter turns off. Suggestions would be awesome!!!! 95-97 Maximas had a problem where condensation from the A/C would accumulate in the a/c evaporator case from the drain ...
Mechanics puzzled and said they've tried everything they know and don't know what else to do. First problem with this a couple weeks ago. Started up as usual, drove 4 miles,turned at a exit, car died.
...and inserted a light. All the cylinders lit the light fine except 1 and 3. What do think the problem is and can I fix it myself? check timing ...
No start Had Codes p0340 & p0345 both are cmp sensors. Replace both and still no start has no injector pulse and spark. The crankshaft position sensor works in tandem with the camshaft ones, and ...
97 maxima brake pulseing problem. hello my 97 maxima brake pulseing problem, the pads and shoes are less than a yr old, all new brake lines. the pulsing does not happen on cold days or in the morning.
pulse but it will not run. Have a Snap Vantage Pro have check TPS, both Crank sensors and also cam sensor. I going to check timing chain by getting no. 1 up on compress stoke and check crank alignmrnt
...particularly the crank sensor. And, maybe swap out a computer ito see if that rectifies the problem, since the computer controls the injector pulse assuming it gets a signal through the
...12 ohms. At 18 ohms intermittent fault codes will occur. At 40 ohms the solenoid fails to operate properly and the engine's performance deteriorates dramatically. . Whilst the resistance is an ...
mix sent by the ECU. This could be due to a very bad coolant temp sensor, or some other strange ECU problem. The plugs sparking only once could be ECU cutting spark due to sensor out of limits
Usually answered in minutes!
1,308 Questions
1,122 Questions
1,007 Questions
857 Questions
783 Questions