Questions & Answers for: Canon MultiPASS printhead jam

...printhead holder cannot move. This is usually due to a paper jam. Clear the jam (or whatever might be obstructing it) and then press "Resume". Do NOT try to move the printhead holder manually. As for ...

...not jammed, inks are not empty. Any ideas? Try to bring it back to factory by removing the ink and printhead.remove power plug from wall or unit for a half hour,re-install all ink and printhead and ...

...sticks on the right it means the purge assembly is not working properly. The printer locks the printhead on the right to cap the printhead and during cleaning. It is driven by plastic gears that ...

keep getting same message. Any help??/ Too many things can cause that, paper jams, carriage errors, printhead problems, purge assembly errors, feed roller errors, need more info to be of any help

..."check printer" and then "##345" 345 says paper jam or printhead problem, press continue, remove any jammed paper, try re- installing the printhead, the error is an internal communication

...even the manual says it's an internal unit malfunction, and you should remove and reinstall the printhead, clear any paper jams, and cycle the power off and on. When it doesn't help you need a

...and push resume doesn't work. Ink cartridges are full. Any suggestions You need a shop to help with that. At this point it could be anything, paper jam, purge assembly stuck, printhead bad,

...the jammed paper. (Check the paper edge sensor is OFF.) (2) Press the [OK] key. (3) Reinstall the printhead. (4) Turn the power off and on. (5) Check the service error code and refer to an ...

..."cartridge jammed". Does that Alarm message says "cartridge jammed". Does that mean the printhead? If so, the printhead still moves when you turn the printer on/off. When you turn it on, ...

...click, click. The printhead doesn't move to the center and I continue to get a message to check printer. Sounds like a bad jam and would need a canon service centre to fix erro 225 in fax cannon ...