...Printer control board (PRCB) Developing motor/Y (M20) TCR sensor/Y (TCRS/Y) - first check that the motor is turning correctly, clean sensor, check toner pipes, that the toner is rally moving from ...
...Printer control board (PRCB) Transfer belt motor (M18) Transfer belt unit abnormality When the transfer belt motor (M18) was ON, M18 abnormality detection signal was continuously detected for the ...
Question about bizhub C250 All-In-One Laser Printer
...Printer control board (PRCB) Developing motor/C (M22) TCR sensor/C (TCRS/C i have checked all those parts and tested them with a multimeter and there seems to be no problem is there any other way i ...
...c6500 and getting error code 2861 any help please C 2861= Gamma correction/Y aborted. Patch output voltage is high. Possible causes: Printer control board (PRCB) Developing unit/Y PGC sensor
Question about bizhub C250 All-In-One Laser Printer
...board Inspite doing all these if the problem persists please reload the firm ware/flash firm ware. Last one is to replace image memory board only .no need to replace prcb; overall status board; ...
Question about Bizhub C6501 C6500 Ikon 550 650 Oce Cs620 650 Write Laser Unit C A03ur71200
...Printer control board (PRCB) 4 choice $$$$$$$$$$$$$$$$$$$$$$$$ Developing motor/K (M23) 3 choice TCR sensor/K (TCRS/K) 2 choice 1. Clear black developer counter, replace the black developer an run ...
Question about Bizhub Pro C6500 Printer Control Unit - A03ur75911
...Printer control board (PRCB) Image processing board (IPB) I/F board (IFB) Image memory control board (IMCB) Serious Cost for these boards, recommend a Konica Minolta Tech check this out. Sorry ...
Question about Bizhub Pro C6500 Printer Control Unit - A03ur75911
...these: 3. Printer control board (PRCB) 2. 1st transfer pressing/releasing motor (M19) 1. 1st transfer HP sensor (PS15) remove the transfer belt assy check 1st transfer rollers one each under the ...
Question about Bizhub Pro C6500 Printer Control Unit - A03ur75911
...Printer control board (PRCB) or Paper feed motor (M41) is bad hope its the motor board will be expensive!!!!!!! check behind the draws paper stuck!!!!! also pull out each draw find if thats the ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions