Question about 140XiIII Plus Thermal Label Printer
...left side print right side completely blank Dear sir I have been using 4"x6" lable for printing in 140 XiIII , right now it is printing only left side approximately 3" inch printing and remaining one ...
...change printhead direction? It is printing from right to left on a roll of labels. How do I get the print head to reverse and print from left to right? That is software controlled. Check your
...label is missing on the left side. The paper is lined up but the print head is way to the left. Thanks, Gary Check the Driver Setting if its define the size of your label Q#what software are u
left side of the print head but the righ side s very light. How do I calibrate to darken the print on the right half of the label I think the 105 has an adjustment on the printhead. There are left and
Question about TLP 2844 Label Printer
... if the prints are left justified this is just a setting. If you are saying that the print doesn't come out on the right side there could be several problems. Please find a qualified engineer to ...
finger to put some down pressure on the left side of the printhead while printing. If the print is there, you have your answer. If still no printing, then something else is happening. Hope that helps
Scaling issues with zDesigner 2844-z When printing from a web-page, the page scales as it should if using the universal 2844-z driver. but Using the Zebra Designer driver, it scales off the page. What
Question about TLP 2844-Z Thermal Label Printer
print out on two labels You Have to set label size in the printers driver. A hundred diferent label sizes can be used but the driver must know the size to layout the bitmap correctly Goto printers and
My zebra z4mplus just start printing at the center of the label instead of at the left side of the label. Instead of a normal full printing on a label, now the left half of the label is blank, and the
Question about Z4Mplus Label Printer
...left. I checked the PRINT WIDTH (set at 127 4/8 MM), and the LEFT POSITION (set at 0000) in the printer configuration. Is there a setting that I'm forgetting to check? What would solve this problem? ...
Usually answered in minutes!
402 Questions
235 Questions
259 Questions
211 Questions
195 Questions