washer. no psi out of the box,, using correct nozzle, motor runs, good incoming water psi and volume. ?????????? have you checked to make sure that keyway is installed between electric motor and pump.
Question about Pressure Washer Turbo Nozzle
...as though there is a vapor lock in the wand. the water supply is disconnected and there appears to be pressure is the washer hose. The wand is dirty!! Clean out the Nozzle with a small diameter
Question about Professional Series Pressure Washer 4000 PSI
...pressure washer and it seems to be jammed or locked. Can I repair this on my own and if I can, How? Usually what I do first is pull the pump off the engine. After doing that use your hand to back the ...
Question about Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI
...pressure washer won't turn over. I brought out my Coleman pressure washer today, after it had sat for about a year. I got it all hooked up, checked the fluid levels, and went to start it when I ...
pull start wont pull fully Usually the rewind spring or spring anchor points are broken. The starter must be disassembled and the parts inspected. Remember the spring is under tension! [There are many
Question about Professional Series Pressure Washer 4000 PSI
...pressure washer? If it is a twist coupler which won't turn, i use a pipe wrench or channel locks. If it's a quick coupler socket and the sleeve won't pull back, the quick coupler plug is bad. If you ...
Usually answered in minutes!
95 Questions
11 Questions
8 Questions