Questions & Answers for: Kenmore pressure washer locked

...Washer is level and well-supported. Hope this helps ...... F09 is a Overflow Condition If the Overflow contact on the pressure switch is Closed for more than 60 seconds an Overflow condition will ...

washer is locked and I have tried to hold the control button to reset. It will not open and seems "frozen." I have unplugged it and will wait a while then plug it back in. Any other ideas? To open the

washer says suds and wont work any ideas thank Sud SUDS LOCK (Overdose of detergent detected during the wash cycle) The motor control unit senses a suds lock condition by analyzing the current draw on

...washer stops and blinks F35 and locks up Kenmore Elite front loader washing machine stops and blinks F35 and locks up, tried to run cleaning cycle but the word sud flashes. What can we do to fix this ...

...washer or reconnect power. 6. Check drain pump. 7. Check the pressure switch. 8. Verify CCU operation by running a Diagnostic test or any cycle. Press PAUSE/CANCEL twice to clear the display. I just ...

...washer stoped and SUD was on the ( readout - Where the Timer is ) then now it has a code F35. What can I do ? Hello there: "Sud" SUDS LOCK (Overdose of Detergent detected during the Wash Cycle) The ...

...washer has f32 code flashing. Door is locked and would not open. F/32 error code; this indicates a pressure switch failure. The Sud error code indicates a suds lock condition. Be sure that you are ...

...washer. The analog pressure sensor is shown in the second image below. You can see the location of this component in the first image. It is on the side wall just behind the expansion control board. ...

...washer quit. all lights are flashing door is locked and the code of F - on the display. The machine thinks it is flooded. Either your filter trap is clogges or the drain hose is clogged or your ...

...pressure switch, unplug the washer and remove the top panel. Screws at the very back of the top panel secure it to the washer. Remove these screws and pull the top panel slightly back and then up and ...