Questions & Answers for: Craftsman pressure washer locked

...pressure on the handle to keep it from spinning while you loosen the lock nut. Once it's loose, spin it off and remove the washer and blade, replace and retighten the nut. Should be pretty ...

...Pressure Washer last week and it starts and runs fine for hte most part... After a few minutes it will start bogging and shut down on me. I just read on B&S's web site that high octane fuels burn ...

...washer would be acceptable as long as the splines on the shaft are at or slightly above the top of the pulley but it shouldn't be needed as long as the nut is torqued tight enough. Make sure the ...

...posts if you need more tips and info." Pressure Washer Weak spray Symptom Diagnosis Sears PartsDirect Craftsman Pressure Washer Has no Pressure Common Pressure Washer Repair Problems Pressure ...

...pressure washer. It starts great. The pressure starts out fine. However, when I disengage the spray nozzle lever and then push it again there is along delay before I get any spray. After a little ...

engine lockup I have a craftsman power washer with a briggs and stratton 850 series engine, craftsman model 580752220, the engine will not turnover unless i remove the spark plug, it has electric ...

...start my power washer. the pull start is locked and wont release to start engine. When the pull start gets locked, you have to release water pressure from the wand. I had the same problem last

pressure washer model 580.752191 no pressure building. checked unloader valve and greased the internal parts, and it does flex (had to do it with channel locks) no pressure do you get pressure without

pressure washer, part #580.752700 dies when trigger off. Installed fresh oil, new gas, cleaned air filter and carb and all worked great for a few times. Then started to die when releasing trigger. Now