...pressure washer with honda gcv160 engine. seems to run well, but when trigger is pulled get full pressure for less than 5 seconds before reducing to house water pressure. when left running, looks a ...
pressure in the washer line? Does this washer have an "unloader valve"? What was it doing when it stopped? Or did you just shut it down normally? Can you remove the pressure pump itself from the front
Must wait 30-40 mins to restart engine Craftsman 3000 psi Briggs and Straton- Bought new. Started rightup but after about 20 mins of use I shut it down to add more gas. Woould not restart. Each time I
...washer with a Briggs and Stratton engine. I used it about a month ago and it worked fine. Took it out yesterday and I could not pull the rope to get it started. I took out the spark plug to release ...
...pressure Washer Model 020207. runs forabout 30 seconds then the motor stops. Acts like motor is locked up. Motor can't be pulled until water hose is disconnected. Took the water pump off and the 6.75 ...
washer has low pressure. but can see pressure build up in hose. then when squeez triger motor stops. Hello, W/D here. Sounds like it may be air locked. Connect the hose to the washer. Connect the wand
Question about Pressure Washer Projectpro Spray Nozzle
My sons used the unit 2 to 3 times (8 hrs. total). They put the unit away 5 years ago and has not been started since. I just got it out to try to start. The oil level is good and I added new fuel. But
...off the water....Release all of the pressure off of the hose and pressure washer. Try and pull again. If it still won't pull check to see if there is oil in the engine. The engine may have locked
Question about Gas Pressure Washer 20244
pressure washer locked up, do all the hoses have to be hooked up and water running for the rope to pull the engine might have failed unbolt the pump and see if its the pump that locked up or the
Question about Gas Pressure Washer 20244
...pressure washer, it locks up Try disconnecting the pressure hose and work backwards after that like remove the unloader valve and so on. Contact Flowjet cleaning equipment for help over the
Usually answered in minutes!
56 Questions
50 Questions