Question about F1245W Front Load Washer
...wash cycle you can hear the pressure switch click once then the water stops and then starts to fill again and then it starts to empty if you can help i would like to say thanks know john possible a ...
Question about F1245W Front Load Washer
...wash and rinse cycles so that washing is not cleaned or rinsed. I think the water level pressure switch is at fault because if I disconnect the vacume tube during the cycle, then reconnect it then ...
Question about First Edition FEW12 Front Load Washer
...the door usually if you drain the machine. (only applicable with door interlocks that have a rubber pressure hose attached to them) ?A faulty door interlock ?The pressure chamber can be blocked on ...
Question about First Edition FEW12 Front Load Washer
...our mains water supply was cut off for a few days.Now that it has come back on with reduced pressure the washing machine will not work.The washing machine is only 7 months old.The model no is ...
...or spin out. can hear pump running but think the damage has already been done. would it be pump or pressure switch or something else? If the washing machine won't fill up, make sure that the water ...
Question about GLTF2940ES Front Load Washer
wash. I have the exact same pressure washing washer. I use mine for a lot of jobs around the yard. It is very useful when cleaning off patio furniture, washing off a deck or just washing hard to reach
...which is a result of overloading (see this article) or by overdosing or, incorrect detergent as the pressure sensor will falsely read that there is too much water in the washing machine. Also check ...
...wash tub and the pressure switch. When the water flows into the tub pressure is created in the upper half of the tub which causes the pressure switch to turn off the water inlet valve when the ...
Question about WM-2077C Front Load Washer
...THAT WILL FIT SNUGGLY THEN BLOW INTO IT AND KEEP PRESSURE ON IT AND SEE IF IT GOES INTO WASH CYCLE. IF IT DOES U HAVE A BAD DIAPHRAM IN SWITCH M, BE SURE TO HAVE THE WASHER ON WASH CYCLE WHEN
...the tub when not in use? ( inlet valve) sometimes the pressure switch tube has a hole or blockage in it and will not have the pressure needed to open diaphram and go into wash cycle and it may ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions