...pressure switch detects either water or suds, it commands the drain pump to continue. After 8 or so minutes, if it's still detecting water or suds, the F02 error is displayed. I performed the ...
...pressure switch detects either water or suds, it commands the drain pump to continue. After 8 or so minutes, if it's still detecting water or suds, the F02 error is displayed. I performed the ...
Question about Elite 45986 Front Load Washer
...pressure switch. Works fine on clean washer cycle, but with any amount of clothes in it, we still get f20 error. http://www.fixya.com/support/r3608632-f20_error_code This code is tricky to ...
...Check that the hose is firmly attached with the washer and is not blocked. You can also check the water level pressure switch operation. Please get back to me if you have any other questions. ...
...pressure switch is not working properly and not shutting off the water inlet valve on the fill cycle, or the water inlet valve may be leaking by and not closing properly after the pressure switch ...
...pressure switch. • Verify Drain pump operation • Pressure Switch Hose is in good condition and properly connected to Tub and Pressure switch •Verify there is not a siphon problem •Verify wire harness ...
...switch. the wiring dia. doesn't show the "analog" pressure wiring dia. or we wouldn't need help. I have purchased 3 of these pieces of **** switches. and most of us know that they switched ...
...pressure switch- must activate at the preset/chosen level to give the signal to the program controller to switch on the motor. What is most important for the motor to start functioning is that the ...
...pressure switch. A failed electronic control board in the washer could also cause this problem. To access the pressure switch, unplug the washer and remove the top panel. Screws at the very back of ...
Question about Elite 45986 Front Load Washer
...Pressure Switch:** The pressure switch is responsible for signaling the machine when it's filled with the appropriate amount of water. A malfunctioning pressure switch may cause the washer to stop ...
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions