Questions & Answers for: Homelite pressure dies

...dies. It is spitting the gas mix out the right side by some black cover - same area where spark plug is physically located. What else do I need to check? Spitting gas is not good. It's probably ...

dies. Your symptoms indicate a lean condition. Check to be sure the muffler and/or spark arrestor are open and unobstructed. If all the parts are installed properly and your mixture screws are between

...dies immediately. It also does not sound very good while it's running. Any suggestions???? Thanks in advance! Make sure you are using fresh fuel mix (50:1 ratio). Don't use boat motor oil in a ...

I have a practically new Homelite String Trimmer (model #UT20006 25cc) that has been sitting in the box in my mother-in-law's closet for over 3 years. It will start up like a charm. Fairly easy to ...

...gasket opening up or blown rebuid or replace gasket check for severe scorch in cylinder bore only when hot is your clue expansion leak pressure Boom dies out hard to pull is expansion of ...

...dies .i put a new gasline in it and a new carb kit Why dose pressure build in the fuel tank i removed the fuel line and gas sprayed out relieving the pressure . When you prime/puge your carburetor, ...

...unuseable. Be sure to use COMPRESSED AIR to blow out all the fuel and air passages.The higher air pressure is needed to blow some of the trash/debris from the fuel or air passages. Be careful when ...

dies Hi james....Your float level is set wrong, and or it may be that you did not replace the little rubber seat or it is faulty and the float needle is not sealing.I will give you some info below****

...pressure washer motor reves up and down then dies ut80522d motor reves up and down then dies,replaced fuel line spark plug air filter still no better It's surging... your carburetor needs to be ...

...Sometimes it wont start back up. Please advise. Sounds like a bad unloader valve. Do a search on "pressure washer unloader valve symptoms". When they are faulty there will either be little pressure ...