...pre and main with a switch. If your unit doesn't have pre out/ main in jacks then I have seen it done by putting your equalizer between the tape in and tape out jacks and then select that tape ...
Question about STR-DE485 Receiver
main pre-in & output jacks. To connect through the Tape loop, connect the EQ L&R outputs to the Tape-in (play) jacks of the receiver, then take the EQ L&R inputs to the Tape-Out (REC) of the receiver.
...short-circuited the pre-amp in my integrated amp? any suggestions - can't think of anything else Philbie Sorted it. You have to put the plugs back in the PreampOUt/Main in or it cuts out the
...pre-in/out, main-in/out inputs on my NAD CBE 720 receiver to connect a power amp to the pre-in and pre-out, the headphone jack is disabled. Disconnecting the cables into the pre-in/pre-out every time ...
pre main connection? Hi... I won one of these. Very nice receiver too. You can use the Pre-Main connections OR tape 1 in/out (as long as you select Tape 1 monitor) I dont know what the Ext adapter is.
Pre-amp in Main amp connected to it. To solve (1) disconnect all wires to cartridge. With the turntable connected to main amp - touch each channel wire (that connects to cart) with your finger. If you
...pre-amp will only take the signals from the various sources and amplify them, but only to a weak level. The main reason people would use this is to connect a more powerful amp to the unit. The Power ...
Question about 580ex Flash Main Pcb Pre-programmed Part
...MAIN PCB PRE-PROGRAMMED I NEED TO REAPIR MANY FLASH AND NEED TO BAY THIS ITEMCANON 580EX2 FLASH MAIN PCB PRE-PROGRAMMED TELL SOME PLACE ONLINE AN ESPECIFIC STORE WHERE I CAN BUY THANK Call Alzo ...
Question about Elite 45986 Front Load Washer
...pre wash compartment? A prewash is exactly that a wash that takes plaxce before the main wash cycle for heavily soiled clothes, you can use the same detergent as you do for main wash. I do not think ...
Question about Elite 45986 Front Load Washer
...main cycle after the pre-wash cycle is complete. Leave the items in the washer overnight. In the morning, press the "Start/Pause" button to start the main cycle again. When the cycle is complete, ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions