Questions & Answers for: power wheels charging flashing red

...charging cradle.  Leave it there for 30 seconds.  Lift it up and try it now. Also make sure that the red light on the base is lit up.  This means there is power to the system.  If ...

...charging cradle press and hold the mute button until the red light on the base goes solid, and the yellow light stays flashing. 4. Unplug the power to the base and then plug it back in. 5. Wait 20 ...

...charging base.  Hold it down until the red light stops blinking. 4. Disconnect the power to the base so that the red light and yellow light turns off. 5. Plug the power back in after about 5 ...

...power wheelchair doesnt move, it flashes the first two LEDs in red and when moving the joystick it won't move or make the sound. What could be wrong? The battery is at full charge The Drive Cirrus ...

...red lightas flash and it beeps again and poweres down, It continues to try to trepoqwer multiple times before going in Standy Mode??? Check the projector lamp. sonsunny If the bulb doesnt light and ...

...charging and when you plug in the charger and the power is on the lights wil flash indicating that the charger is plugged in. Now look at the rear of the chair near where the charger cord plugs into ...

should be in the off position when charging, if the yellow bar is flashing during charger, this means the scooter is in inhibit state, Which means it cannot be driven because the charger is plugged in

...POWER BUTTON = BATTERY DEPLETED (Discovery Models) number of beeps after ?uh-oh? : No beeps: A wheel is stuck or is not touching the ground. Pick up the robot, place it down securely on the floor and ...

...power the wheel either as soon as I turn the car on a constant red flashing light is blinking on the circuit board any ideas how to repair it? Or where I can get a replacement part if required I’ve ...

...power chair will pull to the side that is underinflated. ! Determine if the caster wheels are pivoting freely. If either caster wheel is not pivoting freely, the unit will veer to the side. What if ...