Questions & Answers for: Magnavox no power to my tv

...tv power supply board have problems,it dead.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the ...

...nothin The TV is in Calibration mode. Take the original remote and press (Arrow up) (Arrow down) then (The power button on the TV) ((NOT ALL AT ONCE BUT IN ORDER)). Do it over and over if you need

...tv. working on power supply board should be done by a skilled worker. Because there is risk of electric shock even if the power is disconnected. some of the capacitors will hold charge even if the ...

TV still won't power on. Everything else under the hood looks unharmed by the surge. When I plug TV in it doesn't blow the fuse. Help!! Thanks, Most likely your power supply is damaged and

...TV SUNNDNLY WENT DEAD NO POWER I OPEN THE BACK THE FUSE WASE BLOWN OFF I INSTALLED SAME KIND A FUSE AND TRIED DIFFERNE OUTLETS, BUT IT IS BURNING OUT WHAT SHOULD BE WRONG OR WHAT SHOULD I CKECK NEXT? ...

TV will not turn on power went off and when it returned, the TV will not urn on. Check the wall outlet, make sure there is power at the wall. If not, check the breaker panel. If there is power at the ...

...do not replace the diode. Now replace the fuse, your TV is repaired. If you cannot find D620, You will search for D611. In this case the same model TV just a minor number difference (power

...tv. it does not turn on deres no sing of power but i check for voltage whit my multimeter and theres voltage. but in one of the block of the tv were you conect the tv antena de voltage droops 0v when ...

...TV power for about a minute. Plug TV power in. Turn TV on and try remote again. If no luck, make sure no other IR devices are in the room and turn off any lights and try again. If no luck, try a new ...

TV and the power source. Disconnect and reconnect all cables to ensure that they are secure. Reset the TV: Unplug the TV from the power source and wait for a few minutes. Then plug it back in and turn