Questions & Answers for: Ford Explorer power relay

...power door lock relay on 1999 ford explorer does not lock with switch does open with switch Found this answer in anotherr forum and works for me.Power Door Lock Relay Location Aux Relay Box #4 is in ...

Ad

Question about 2003 Explorer

1 Answer

...power relay mini fuses 1=10A A/C relay 2=20A Aux power point 3= not used 4=15A Fog lamps-Daytime lamps 5=10A Air Bag diagnostic monitor 6=10A Powertrain Control Module (PCM) 7=30A 4WABS module 8=30A ...

Ad

...Power Relay 1 10A* A/C Relay 2 30A* Heated Seats 3 30A* Heated Backlight 4 15A* Fog Lamps and Daytime Running Lamps 5 4 3 2 1 10 9 8 7 6 12 11 10 9 8 7 6 5 4 3 2 1 15 14 13 2 1 1 9 6 10 8 7 5 4 1 3 2 ...

Question about 2000 Explorer

1 Answer

...relay, in-turn, controls the Power Windows, Electronic Shift Module, Glove compartment Light and Cargo light...If the fuse is good, suspect the relay...The Interior Lamp Relay and the Battery Saver ...

Question about 2003 Explorer

1 Answer

Relay?? pull switch if no power back track to find open if power switch is bad the a/c relay runs the compressor a/c fuse powers relay fuse is powered by the ecm , ecm gets command from control switch

Question about 1998 Explorer

1 Answer

...relay and power window problem, click the link below:---- Ford F150 power window relay http://technoanswers.blogspot.com/2012/12/ford-f150-power-window-relay.html --------- These will help.

...power wire into the relay or out to the lights may have become disconnected. Try turning the lights on and off several times in a quiet location and listen for an electrical relay clicking. The under ...

Question about 2003 Explorer

1 Answer

...power relay mini fuses 1=10A A/C relay 2=20A Aux power point 3= not used 4=15A Fog lamps-Daytime lamps 5=10A Air Bag diagnostic monitor 6=10A Powertrain Control Module (PCM) 7=30A 4WABS module 8=30A ...

Question about 2004 Explorer

1 Answer

...relay unplugged, use proper size jumper wire between terminals 30 and 87, the power windows should work. If so, the problem should be on the control/coil side of relay, voltage and ground, as you can ...

Question about 1995 Explorer

1 Answer

...power at the relay...wiper hi-low relay... connection at the relay (85) 12v and (86) GEM module you should have voltage there also make sure the key ON ACC when check-in it. same for wiper run relay ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

1999 Ford Explorer
1999 Ford Explorer

2,248 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2004 Ford Explorer
2004 Ford Explorer

1,513 Questions

Manuals & User Guides

Loading...