...power cord and re plugging it in, occasionally the leds would light, then the toaster would work, until it stopped again. FIRST A WARNING! YOU CAN KILL YOURSELF IF YOU PULL APART A TOASTER, THE ...
Broken metal lever arm for 3/4 slice switch Hi, I need to source the above part but no-one seems to sell parts for this toaster. Has anyone found a suitable parts source? It looks like it's made of a ...
Question about 10617 Glass 2-Slice Toaster
russell hobbs microwave will not work, but grill & oven ok. model no HOB CJS28. Microwave counts downs and beeps when finished, but food still cold. The grill and oven parts work. The magnetron ...
russell hobbs microwave RHMM20 not heating not heating Open fuse Magnetron failure Door interlock failure Control board failure
Question about 10617 Glass 2-Slice Toaster
Hi my russell hobbs steam glider 20580 when heated leaks water instead of steam only had it for a couple of months got it as a gift I'm in pakistan now so there is no way to get it sent back No steam ...
Question about Steamglide Professional Iron [14733]
my russel hobbs stopped working in the middle of ironing light off and cold. its 2 years old, still in perfect condition but wont get hot. Could be abrupt heating element failure
Question about Steamglide Professional Iron [14733]
What in numbers are the 5 power levels on my Russell Hobbs 2060b microwave I've just got it and find when I use t T 800 I am burning the food The magnetron has a 100% duty cycle on full power and ...
Question about Steamglide Professional Iron [14733]
Russell Hobbs ultra glide 3100w iron red power light flashes when the iron is turned on from cold and iron doesn't heat up, would appreciate a steer on this. thanks CONTACT THE MANUFACTURER'S TECH ...
Question about Steamglide Professional Iron [14733]
Russell Hobbs blender no power fusses are ok model no rhb314 Check continuity of the power cable. Contacts of the power switch. Carbon brush of the motor.
...power supply. It pushes two voltages, 5v and 12v; its 12v turns out to be ~10.8v. To verify, I inserted an external 12vDC feed into the 12v wire and lo and behold - everything starter working just ...
Usually answered in minutes!
24 Questions
2 Questions
12 Questions
23 Questions