Questions & Answers for: Whirlpool Cabrio power drain

...power back on, nothing happens. HOWEVER... I have realized that if I turn off the washer and let it " cool down " for 5-6 hours the washer will then work normally. If I try to do a second load, it ...

...drain is the pump. With the back panel still off the washer, check the pump with the voltmeter to ensure that the pump is getting power. If the washer is getting power, turn on the washer and listen ...

...power. 6. Check drain pump. 7. Check the pressure switch. 8. Verify CCU operation by running a Diagnostic Test or any cycle and replace the part that has gone bad. Please do rate the solution if the ...

...drain hose 2.The drainpipe (standpipe) height requirements are: 96" (244 cm) maximum and 39" (99 cm) minimum. Your washer will not be able to adequately pump the water out of the washer if the ...

...drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF! At this point it is also possible to test ...

...drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF! At this point it is also possible to test ...

...panel as well. Plug in washer or reconnect power. If the issue is still not resolved then you would need to replace the drain pump. Hope this helps...please post back for further assistance. ...

...drain systems for Cabrio washers. The example shown is for an impeller washer but is applicable to washers with agitators: whirlpool.com/files/usr/animations/ANM000014 Keep in mind that to remove the ...

...power is restored, and I turn to DRAIN & SPIN, again the "motor" hums, and nothing else, the buttons again will not respond. I have turned power off at the breaker again and left it off ...

...need to check each of these using a multimeter, make sure and take precaution with the mains power and use proper insulation.Remove drain pump to check for clogging or jamming within the unit.