...Network light on is flashing I had this issue with my 6988 printer---the solution was to unplug the power cord and then press and hold the power button for 30 seconds---thus draining off the static ...
...Power Drain] >>Turn off the printer by disconnecting the power cord from the back and also disconnect the power cord from the wall outlet >>Then Press and hold the ON button for 30 seconds. >>Connect ...
...POWER DRAIN:-Turn off the printer, Unplug the power cable from printer and from the wall outlet.Press and hold ON buton for 30-60 seconds. NVM Reset: --Take the Ink Cartridges out. --Unplug the ...
Power supply blew again. Same components plus a resistor this time. It has been repaired once again and tested with the main board plugged into it. I suspect a motor - seems the most obvious component
...Power Drain: Unplug the power cord from the back of the printer, then press & ho;d the power key for 30 seconds, then release the key & plug in the power cable back. Check if the problem is ...
Question about DeskJet 3650 InkJet Printer
hp deskjet 3650 printer works very slowly with win 7 tion one: Check the power supply Follow these steps to check the power supply to make sure that it is functioning correctly. Turn the product so ...
Question about DeskJet 5150 InkJet Printer
...drain the power from PC. Follow these steps to resolve the issue 1. Disconnect the printer power cord from walljack or surge protector 2. Disconnect the USB cable of printer from PC or vice versa 3. ...
...Power Drain:1. Unplug the printer power cord from wall and the printer, disconnect USB cable from printer.2. Press and hold the power "ON/OFF" button for 30 seconds and release it.3. Connected the ...
... Example tool with list of HP products installedStep two: Run the Print Diagnostic UtilityPress the Power button ( ) to turn on the product, if it is not already on.From the Printer column in the ...
Usually answered in minutes!
2,162 Questions
707 Questions
530 Questions
316 Questions
318 Questions