Questions & Answers for: TC Electronic power on delay

TC Electronic D-Two Power unit locked up display This TC Electronic D-Two unit has a problem with the power supply. The dc supply voltages to the mainboard (3.3vdc, 5.0vdc & +- 15vdc) are always ...

...348 and then press the buttons Normally you must HOLD a set of switches down while turning on power AND continue to hold them UNTIL screen acknowledges the function... try it... I have just ...

...about how you have this chained together. DO REMEMBER that ALL interconnected equipment MUST be powered from the sme source or receptacle for system safety. It sounds like you have mixers tied ...

...a bad ground loop. IF that is an old Marshall head that doesn't have a three wire (with ground pin) power cord on it, take it in immediately to have a three wire grounding cord on it before you fry ...

The problem I have is the following: I have a powercore firewire and a powercore compact. They were sounding perfect until I bought three plug-ins: the TubeTech CL-1B, Tap Factory and Harmony 4. At ...

...delay pedal buzzes when activated. Alone or in a chain, its noticable. not the guitar, cables or amp through process of elimination. We were wondering if you've ever seen this before? Make sure ...

...being produced. and the unit will not respond to any of the buttons being pressed. On shutting off power and plugging in again, the unit powers up and can be used again, but then locks up again. Can ...

will not power Fuses checked? Make sure you use a voltometer and not just eyeballing it. FYI.

...BG250 schematic I have a dead amplifier and am trying to locate its wiring diagram. I suspect the power supply is the cause. Thank you. Try Googling (TC)(BG250)(manual) without

With the correct power will my TV & Surround system work as a streaming device in the Uk. I understand that the network would not be available? Not sure what you are trying to do. If you use an ...