Questions & Answers for: possible load security please try Sewing Machines

...load autopunch and open the Futura software. I did turn off the auto updates but if I'm reading this right I have to remove the updates as well, right? I have to turn off startup type, right? I am so ...

try it again. I have tried this several times, I have unplugged the machine and tried again, I have disconnected and reconnected the carriage and nothing seems to work. Please help!! I miss working on

...load the Futura CE-200 software (1.0.0.2), hook up Futura and get the following error message: "The application failed to initialize properly (0xc0000005)." Then a screen (Singer #4904 error message) ...

...Security". Please help. called singer and they sent instructions Hi, Ok ! lets get this one solved..First of all uninstall service pack 3, then uninstall auto punch,hyper font ect.( this includes ...

I was able to download designs to my computer using a flash drive the first time. I attempted to download again for the second time using the same flash drive. I plugged in the flash drive, pressed ...

...possible that the foot you are using is not an Elna foot? Elna later changed to "Low Shank" clip on feet with the Air Electronic range and these should be interchangeable with your Stella. I found a ...

...possible thread, but for the third time, the needle stops about half-way down so you can't release the material being sewn, - can't release anything. I did remove the bobbin and bobbin-holder, then ...

...load It is likely the software you have is not supported by the computers operating system, this is true of MS Windows 7 and up operating systems. You likely have software for the older XP system. is ...

...again. Please help! :) Sounds like the display is going bad.. it may need replacing. I they are very hard to find them and the dealer only wants you to buy a new machine. Sometimes you can find them ...

...Please advise Typical causes are bent needle, needle not seated fully into holder, needle orientation, needle threaded in wrong direction, and bobbin spool loaded backwards. Be sure to follow the ...