Questions & Answers for: Oldsmobile position light

...light goes out, that's the one that cause the drain. check and fix that system My 1992 Oldsmobile 98 will not turn over with the key but starter will spin engine when bypassed. Just stopped starting ...

...position. Seat belt light may flash, but no flashing security light, just a solid red security light. The learn procedure does not work for me when the security light is on. The car will not start, ...

...light switch is in the on position and driver door open. if headlight switch is off, headlights are on but tail or side marker lights do not light up in any state the bright switch, dash lights and ...

...light switch is in the on position and driver door open. if headlight switch is off, headlights are on but tail or side marker lights do not light up, in any state the bright switch, dash lights and ...

...position. If the "Security" light is flashing allow the key to remain in the "Run" position for at least 10 minutes. After 10 minutes have passed look to see that the Security light has stopped ...

...light is switched to ON position if no then you likely to have a bad door trigger switch Adjust the dome light switch by moving the switch lever to a different position. If this does not work, either ...

...position. ?€¢ The ambient light sensor indicates darkness. The lamp control module (LCM) monitors the ambient light conditions through the ambient light sensor. The ambient light sensor is a variable ...

...position. ?€¢ The ambient light sensor indicates daylight. ?€¢ The vehicle is not in the PARK position. When the above conditions are met, the lamp control module (LCM) supplies battery positive ...

...position. • The ambient light sensor indicates darkness. The lamp control module (LCM) monitors the ambient light conditions through the ambient light sensor. The ambient light sensor is a variable ...

...position. Does the test lamp light? -- Go to Step 3 Go to Step 7 3 Disconnect the turn signal flasher connector. Connect a fused jumper from the turn signal flasher connector cavity A (PNK) to cavity ...