3.L 2v or 4 valve? 3.0L (2V) Engine SPECIAL SERVICE TOOL(S) REQUIRED Description Tool Number Syncro Positioning Tool T95T-12200-A CAUTION: Prior to removal of the camshaft position sensor (CMP sensor)
windshield wiper is in the up position the wiper blades are in the up position when you turn the wiper control to the off position. wiper motor bad
...panel steering column cover (04459). Rotate ignition switch lock cylinder (11582) to the RUN position. Disconnect the ignition switch electrical connector. Remove the two screws retaining ...
...the ignition switch electrical connector. Rotate the ignition switch lock cylinder to the RUN position. Remove the two screws retaining the ignition switch, and disengage the ignition switch ...
...hose clamps at throttle body and engine air cleaner assembly. Remove air cleaner outlet tube and position aside. Remove radiator overflow hose from the radiator, disconnect two hose locators at
How to replace positive cabel on 1996 Mercury Sable Remove negative cable from battery than remove positive cable from battery. jack car on passenger side make car safe by putting jack stands under ...
Where is the Throttle Position Sensor/Throttle Position Indicator the throttle positioning sensor is close to the throttle plate area, on the throttle body of the vehichle.
What's a tps switch What's a tps switch TPS = Throttle Position Sensor. it used to monitor the position of the throttle in an engine. it usually located on the butterfy spindle so it can directly ...
Hood will not shut If you mean the hood will not lock down in a closed position the following applies. It can be due to a stuck hood release cable or latch pivot that is out of sequence. With the ...
Question about 1991 Capri
...That should be controlled by the switch and not the motor. I would get both head lights in the same position and start them together by disconnecting battery for 10 seconds and starting back together ...
Usually answered in minutes!
1,305 Questions
689 Questions
627 Questions
646 Questions
630 Questions