Question about Baracuda G3 Automatic In Ground Pool Cleaner
zodiac x7 quattro won't move, even with the flow set right. unscrew the collar just above the handle and push the pipe inside downward. visually inspect the diaphragm for debris or damage. This is the
Question about Baracuda G3 Automatic In Ground Pool Cleaner
...pool has been backwashed and filtered and the pressure is fine. check the diaphragm for debris, damage, or deformity. unthread the collar above the handle and push the tube downward. Inspect the ...
pool cleaner working very eratic , stop /starts you probably need to replace the diaphragm, unthread the nut directly beneath the wagon wheel, press the white tube downward and inspect the rubber ...
Question about Baracuda G3 Automatic In Ground Pool Cleaner
...proper flow), it is probably your diaphragm. Check the diaphragm for damage or wear. If you see that there is damage or wear, replace the part. This should solve the problem with the pool
Question about Baracuda G3 Automatic In Ground Pool Cleaner
...pool cleaner is losing suction, there are several things that you need to check. Check the diaphragm for damage. Make sure that you don't have air leaking into the cleaner. Check all of the returns, ...
...Zodiac pool cleaner and replace it with a larger one which i have already purchased, without damaging machine or wheel. REASON: The zodiac is getting stuck in a tight corner at the base of the pool ...
Question about BARRACUDA G3 IN-GRND CLEANER
...damage to that diaphram will cause the cleaner to not work. If it is only 6 months old then it is under warranty. any pool store should be able to get you a new diaphram at no cost. bring your ...
Question about Baracuda G3 Automatic In Ground Pool Cleaner
pool cleaners if you are sure that the suction is not a problem. Normally, I would start by suggesting you check for blockages and obstructions in the cleaner, filter, and skimmer. However, if you are
Question about Baracuda G4 Automatic Pool Cleaner Ne221
...pool cleaner stops running as if losing suction.pump pressure normal, no bubbles indicating leak. take apart, then assemble, clear air from pipes, connect to suction point, run 4-5 seconds, then stop ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions