Questions & Answers for: plug wire location ignition coil

Question about

1 Answer

ignition coil and ignition control module part of the distributor? Hi, common thing with the mazda was the coil or the ignition amplifier going faulty, both of which are located within the distributor

Ad

...plug wire on top of the spark plug. The front ones are easy to replace and all 3 can be done in about 30 min. The back ones are another issue. I had to take off the intake manifold on the top of the ...

Ad

...watch the rotor go around. look at the cap and wire to see where # 1 is. I locate #1 plug and wire before I pull the dist cap. When it pushes out air it must be pointing to # 1.... hope this helps ...

...ignition / fuel injector. ECT/MAF sensor. ECM. not that i need to tell you but you have a misfire on cylinder one, check the spark plug <> HT lead <> injector <> low compression, as ...

...ignition coils, the spark plugs are under them. When you have them off before pulling the spark plugs make sure the holes the plugs are in do not have oil in them, if so you will need new coil boots, ...

...Ignition Coil Connections: (back) ...1 ...4 ...2 ...3 (front) For the 3.3L V6: Firing Order: 1-6-5-4-3-2 Cylinders: ........(back) 2.........4.........6 1.........3.........5 ........(front) Ignition ...

...Ignition Coil Connections. I have included all three (3) types of Coil Systems for the Park Ave, Park Ave Ultra, and Park Ave with a Supercharger. For ALL the 3.8L V6: Firing Order: 1-6-5-4-3-2 ...

plug wire diagram position from distributor to engine on mazda 626 4 cylendar For the 1996 Mazda 626 2.0L DOHC In-Line 4-Cylinder: Firing Order: 1 - 3 - 4 - 2 Cylinders: .........(back)......... |..1.

Question about 1996 626

2 Answers

...plug wire diagram for 2005 mazda 6 2.3L 4 cylinder? After removing the plastic engine cover, look at the top of the ignition coil. It should be numbered 1 through 4. This is plug number 1 on the ...

...PLUG, PIN B5, and the UNLOCK wire is a WHITE (TYPE B) @ the BCM, LT BLUE PLUG, PIN B10. NOTE #5: On BASE Model trucks, the Door Trigger wires are @ the BCM, LT BLUE PLUG, PINS B4 and A5. On 4-Door ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...