...broke a piston (still runs)! my 83 F-250, 460 cid, broke a piston (still runs)! I'm unemployed and broke! can I drop the oil pan, remove the rod and piston from the bottom, and replace only the ...
...definately have bent over in the process? yes new heads are in order sorry YEP.IT DEPENDS ON WHERE PISTONS ARE.WHEN CHAIN BROKE.BY LUCK I HAD A 4 CYLINDER ENGINE.MY TIMING BELT BROKE.LUCKLY ALL MY ...
...piston broke causing damage to the housing. I replaced piston and sleeve. I fired it up today hearing odd noise. The same piston was broken again! You may have also bent the crankshaft or scorned the ...
broke while trying to push back the piston, the piston is seized in the bore of the brake cylinder OR you have the style of piston that winds in anti-clockwise as you push the piston back in.This will
...piston if the timing belt broke? I'm assuming you meant if the timing belt broke would the pistons hit your valves? 2 parts to this, #1 if your belt just broke you should be fine, #2 if your belt ...
...broke on my 2001 sportage and didn't do any damage. This is due to the fact that the engine is called a "non-interference" motor. At no time can the valve hit a piston (in theory) because the ...
Question about 2003 Spectra
...mph what probably happened is that when your timing belt broke the #3 piston most likely hit the valves hence the lost of compression. you will need to take the cylinder head off and have it
Question about 2005 Tucson
...it to rebuild top end ? I would say so, most probably the valves have been bent by hitting the pistons when the belt broke. When the belt breaks, the valves stop mmoving, and the pistons keep ...
...broke a valve and messed up the piston I already have the head off. Remove the oil pan and unbolt the connecting rod from the crankshaft on the damaged piston and push it up. It will come out without ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions