Question about 1992 Ranger
...pinion seal. You also might check the fluid in the transmission most of them take plain old dextron atf I would use a synthetic if your gone to drain and refill. Most clutch noise I have heard is ...
pinion seal how do i replace the pinion seal on a 1990 ford ranger? remove the drive shaft at the pinion flange move it out of the way, then remove the pinion flange on the differential nose, the seal
...pinion seal?) 03 4X4 ford ranger I have a 03 Ford ranger that has a leak at the rear diff where the drive shaft hooks into the differential plate. It appears there is a plastic lipped washer and the ...
rack and pinion can u grease the inner tierod boots on a 2001 ranger i think i put to much and was worried it might get inside the rack and mess it up hi, the inner tie rods on that truck are ...
...the rear wheels for any oil leaks. Also ckeck the pinion seal. But get oil into the filler plug before you do anyting else. You could have the wrong fluid in it or it needs the clutch additve put in ...
Rear pinion seal2002 ranger 4x4 FX4 leaking remove the yoke and istall new seal it takes about 1hour
r/r differential pinion gears while changing axel seals the pinion gears fell out and I can't get them back in I think its diff out they fit from the top,i am not 100% certain i hope i am ...
...it is a 7.5 ring gr I changed both axel brgs and seals no changfe The noise is most likely a worn pinion gear bearing. There are 2 bearings on the pinion. The diff will have to come apart to
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions