...pinion seal int he rear of this car? Also, could I possibly need the crush sleeve replaced? The car shifts okay.....Thanks this is for 2003 7.5 inch ring gear axle. SECTION 205-02A: Rear Drive ...
...pinion seal that will need to be replaced. Take the driveshaft loose from the rear end. You will then see a large nut, probably 1" or larger. You will need to remove this with an air impact wrench. ...
...disc brake calipers and rear disc brake rotors. Working through cover opening, remove differential pinion shaft lock pin and remove differential pinion shaft and differential pinion gears (4215). ...
...seal (pinion) on a 2000 Mustang? Can I just remove the bolt, or do I have to mess with the backlash internally? remove the nut the yoke and the seal in that order be sure to mark the drive shaft ...
...PS lines (a pressure line and return line) run from the pump and reservoir down to the rack and pinion unit below and behind the engine. Lines can rupture and leak, hose connections can leak,
Question about 1966 Mustang
...pinion nut until there is a slight drag. If it's too tight the bearing will heat up, if it's to lose it will wobble.Ideally the nut should be tightened with no seal in it and out of the carrier, to ...
Usually answered in minutes!
706 Questions
694 Questions
653 Questions
589 Questions
617 Questions