...the mechanic is saying is correct. Their are many measurements required to do this correctly. The pinion has to have the correct height adjustment so it rides even with the ring gear. This ...
...pinion nuton rearend!!!!!! If your car is a rear wheel drive, and you mean the nut that's just after your drive shaft, then...If you are replacing the seal, you need to mark the nut and the shaft so ...
...pinion seal repaired on 1995 v-6 camaro 36000 miles ,bearing failure 1800 miles later, no water , mechanic says he never removed pinion nut or crush collar , is this possible!! thanks mike He had to ...
rack pinion boot leak bad the seal in rack is no good, the boot is there just to keep dirt off shaft,you must replace the steering rack,good luck.
...to burst when this happens can you please tell what the problem might be. the seals in the rack and pinion are blocking the fluid from entering the left side,no one repairs racks any more they just ...
...diff. in order to change the bearings and seal? you need to open the dif and remove the locking nut and pinion shaft. Then push the axle in towards the center to remove the C clip thats on the
...seal 3rd Gen Camaro ring gear #GM3984825 15 41 12 75 You must remove the rear cover of the differential and then remove the bolt that pins in the center pin that the pinion gears are mounted on, then ...
Usually answered in minutes!
737 Questions
576 Questions
468 Questions
391 Questions
331 Questions