Questions & Answers for: GMC pinion seal

...pinion nut, I had to replace the seal only I pulled the yoke off and did not check for a rolling torque first is there a way to just torque the nut and set the preload Only way I know of to do it ...

replaceing pinion seal on 2004 yukon took driveshaft out took nut and washer off cant get yoke off pinion. what do i need to do you will have to get a yoke puller, they do go in thight

...seal reinstall the flange, snug it up, untill it is seated, then give it a small amount of tightening. You should not over tighten this nut, as it could result in pinion bearing damage. If you use ...

ft differencial pinion seal is leaking. I have replaced it and it is still leaking. Pinion needs shimmed, or the bearing is bad. It will have to disassembled to do either.

pinion seal,,do u need a puller to remove the yolk? To remove the yoke, you need to remove the nut on the end of the pinion shaft. When you do that, you MUST count the turns as it comes off, including

...pinion seal or the cover gasket. To replace the pinion seal, remove the driveshaft and let it hang ( it shouldn't come out of the tranny). Remove the pinion nut and the pinion yolk ( may have to ...

...pinion. If removed to replace the seal, you were supposed to count the number of threads exposed on pinion shaft beyond the nut, and also mark the nut's position relative to the shaft by using a ...

...seal for the pinion. ou need to remove the drive shaft off the pinion yoke thene you will find a big nut in the center of the yoke that has to be removed but before you remove the nut check to see if ...

...pinion yoke, oil seal and bearing. There are a number of things that need to be checked on the yoke before replacing the bearing and seal (such as tool marks, nicks and worn groove caused by the oil ...

...pinion oil seal means the nut should be marked prior to removal and returned to that position - plus a gnat's wotsit, so the pinion bearing preload limit isn't exceeded. I suggest you discover the ...