Questions & Answers for: pictures slaves

need to make maxtor drive a slave drive is set up like this, :::.: The far left two r connected vertically. The next TOP two r connected horizontally. How do i set them so that this drive is slave? Hi

Primary ide slave no detedted secondary ide slave not detected computer dont start up properly you need to verify the jumper settings on the devices that are connected through the IDE flat cable. ...

What is the jumper setting for 'Slave' on Maxtor What is the correct jumper setting for 'Slave' on a Maxtor 6L160P0 160 Gb Hard Drive? Can anyone supply a diagram? Look at the picture, I cannot ...

where is slave cylinder on mr2 the clutch slave cylinder is bolted to the bell housing of the engine, here is a picture.

where is the clutch slave cylinder located on a 1992 Honda Accord the slave is located on the side of the trany, if you open the hood and look behind radiator at trany you will see it bolted to tranny

try to bleed you slave cylinder. Locate the slave cylinder and follow the instructions and location pictures below. Be careful though when you got to unscrew/open the bleeder valve not to break it off

...the clutch slave cylinder but just not sure if I am loosening the right part. Can't find any pictures. There is only one bleeder valve on the clutch slave cylinder so you can't be

cluch has no pressure i need to know how to refill the trany Try CHECKING AND refilling the master cylinder for the clutch on the firewall under the hood, it looks like a small brake master ...

do i have to drop the transmission to fix the leak on the slave cylindar and would it leak out faster if the hose was cracked or leaking at the slave cylindar The Clutch Slave Cylinder is leaking on ...

location of slave cylinder? Here's a link to a picture of the slave cylinder,just disconnect hose from cylinder and have a container and rag to catch fluid,then remove both bolts,real easy,after you ...