Question about ViSYS 2-Line Speakerphone
phone to call out, there is a message that says quot; A message is waiting for you quot; and then we get the dial tone. Please HELP!!! on the base set, press and hold the voice mail 1 button. You will
...into the line socket sometimes this may be marked line/tel then the hand held phone goes into the tel socket.this should make it a little clearer..line to wall socket ....and tel to hand ...
...phone base, the wall outlet, the outlet where the telephone modem is and at the L1/L2 jack on the back of the telephone modem. Your phone is not getting the dial tone line voltage from the telephone ...
...base unit due high current surge.If the dial tone didn't heard from the other phone also check for the corroded line cord or modular box fault with the tel line.There should be 30 Volt-50Volt ...
Question about DECT 6.0 Cordless Phone ID
...base. Make sure that the cord is inserted correctly in the TEL LINE jack on the phone. When you insert the cord you should hear a click. Insert the other end of the cord to the wall jack. Make sure ...
...cordless uniden phone display reads check tel line... one cordless (out of 3) cannot be located... instead of dial note, getting busy signal,,, Hello Try re-registering the hand held to the
...phone from electric and wait aminute or 2 the plug it back in. If the base unit is working and the extension is not ,take the hand set and set it in the charger for the base unit it will reset the ...
Question about Cordless Phone
...base to the appropriate phone jack on the Uverse box, the phone face read out says, "Check Tel Line". Any ideas? make sure that the service provider has connect your line in the exchange if ...
...cable conections from phone box on wall to base unit, make sure that the conectors are fully inserted. If possible plug a different phone into box to make sure that line is working. Hope this ...
Question about Cordless Phone
...base unit is connected to the landline and operates any hand set that is picked up make sure all handsets have the end call button pressed as one not pressed after use may keep a line open call your ...
Usually answered in minutes!
3,453 Questions
1,326 Questions
1,157 Questions
1,197 Questions
607 Questions