Questions & Answers for: pedal switch

Question about 2002 Civic

2 Answers

...pedal position switch(lower of the 2 switches) locknut and back off the clutch pedal position switch. loosen the clutch push-rod locknut and turn the push-rod in or out to get the desired height and ...

Ad

Question about 2003 Grand Marquis

1 Answer

Pedal Switch C290 Disconnect the adjustable pedal switch C290. Measure voltage at C290-1 and C290-7. Is the voltage greater than 0 V at either pin? Yes REPAIR the short to battery. TEST the system for

Ad

...switch by the brake pedal and i notice another switch controlled by the foot pedal. What does this switch control? Thanks. I have a 1999 mercury Villager . I was adjusting the brake light switch by ...

...pedal and check out the switch itself. Many pedals use a switch that can be used either way. The clue will be on the switch itself. If there is an extra tab on the switch that is unused, then switch ...

...pedal switch has become misaligned with the pedal itself and when you depress the brakes what you are hearing is the pedal rod sliding alongside of the switch housing try and see if the pedal is ...

...pedal position switch (CPP) is controlled by the clutch pedal. Depressing the clutch pedal manually closes the CPP switch and allows engine cranking. The CPP switch will also deactivate the speed ...

Question about 1988 Dakota

1 Answer

...switch-to-pedal bracket screw and slide the switch away from the pedal arm. Push the pedal down by hand and allow it to return on its own to the free-hanging position. Do not pull it back! Fig. 1: ...

Question about 2002 A4

1 Answer

...switch toward the brake pedal arm, as far as you can without using excessive force. Next, return the brake pedal to the pedal stop position against the pedal stop and pull the brake pedal toward the ...

pedal switch that you create by yourself. Use stereo phone jack and cable. It can be function for 1 or 2 switch. Setting function for SUB-EXP-PEDAL is at UTILITY-GLOBAL menu. You can set switch 1 or 2

Pedal Position Switch Test 1.) Disconnect the 4P connector from the switch (A). 2.) Remove the brake pedal position switch. 3.) Check for continuity between the terminals according to the table, using

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...