Questions & Answers for: pcm 1998 ford expedition

ford expedition on your own if so how You should be able to perform that task without much difficulty. The PCM is located beneath the dash on the passenger side behind and above the kick panel. You'll

...the best action here is to take it to the local ford dealer for a PCM scan. you should receive a code that will point to a transmission OD shift solenoid issue. Please rate and god

...1998 FOrd Expedition, 4.6L. Where can I get this part? Thanks, Alec Code indicates bad EGR Vacuum Solenoid. Chilton lists possible causes below. Here's a link to the part you want. Best of luck! Greg ...

...ford expedition...O2 sensor? If so whitch one? CODE PO171 -SYSTEM ADAPTIVE FUEL TOO LEAN. POSSIBLE CAUSE.AIR LEAKS AFTER THE MAF SENSOR OR LEAKS IN THE PVC SYSTEM. EXHAUST LEAKS BEFORE OR NEAR WHERE ...

PO171TROUBLECODE P0171 indicates that the long term fuel trims have reached a maximum (should be somewhere around 30-35%). Fuel trims are how much fuel the PCM adds or subtracts.

...pcm and the ecm--5.4 litre 1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl PCM Ford's Location: * Ranger - behind instrument panel (cowl), center to both driver and passenger sides. * ...

check engine light is on The PCM (Power train Control Module) has noticed something isn't as it should be. You'll need to find someone with a scan tool or take it to a shop in order to find out what ...

...ford expedition In the Power Distribution Box-the fuse relay block under hood- it's on the driver's side. it is fuse # 24, a 30 amp green fuse. This fuse is only hot in run or start, so with key on, ...

...1998 Ford Expedition is over charging. I replaced the altenator about 3 months ago. Could the PCM be causing this? The other day, when I started it, it almost died twice, but it ran ok all the way to ...

...1998 ford expedition 5.4 engine https://www.youtube.com/watch?v=IiIWfoEwwqI It's in the valve cover on top inside a big grommet and a hose is attached to it please go to rockauto.Com and look up your ...