Questions & Answers for: what does pcb stand for Food Mixers

...This is an old machine which suddenly stopped and emitted a lot of smoke. I believe the Control PCB assembly has become defective as the continuity across the windings of the motor appears

I am looking for PCB diagram for Kenwwood KM201 mixer. The one capacitor has blown and looks like a resistor as well. Can't see the values. Try http://www.torreelectrics.co.uk

it is not working completely. all fuses and door switches are well pls help check the power cord possible damage and the motor resistance if ok. also the pcb board

...plate at the back is stuck in the high position or you need a new phase board. That's the small PCB under the back cover at the

goes too fast...one speed only..fast! Probably needs a new phase board, that's the small PCB under the back cover at the top with all the wires coming out of it.

...stand mixer is spinning too fast after a voltage fluctuation. I was using the mixer to knead dough, I switched it off for a few seconds and when I turned it on again it started going at high speed ...

KitchenAid mixer runs at full speed only It is most likely the phase board which is the little PCB under the back cover at the top, it has 4 wires coming out of it that plug into the black speed ...

...If nothing is sticking in the movement of the control plate at the back I would replace the little PCB at the back just above the control plate. Where I live it is called a phase

...Stand Mixer? Will not power on at all. Remove the top cover, screws are under the metal trim band with the writing on it. Get a multi meter and follow the power. Where the power stops is a good place ...

...stand mixer 500 watt speed control not working. Accelerates and drops speed itself. Have so far new PCB ordered changed and nothing happened. The system have only two electrical parts the electrical ...